TM-9-2320-366-34-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4
AUGUST 2005
CHANGE 2
TM-9-2320-366-34-2 - Page 575 of 1434
TM 9-2320-366-34-2
Change 2
10-24.1
(6)
Press two bearing races (9) in housing (10).
(7)
Install housing (10) on shaft (2).
(8)
Position bearing cone (11) in housing (10).
(9)
Position mounting plate (12) on shaft (2) with three
screws (13).
(10) Tighten three screws (13) to 150 lb-ft (203 N•m)).
(11) Measure bearing backlash from frame rail (16) to front
side of houseing (10).
CAUTION
CAUTION
Use care when installing housing.
Seals are
easily damaged.
Failure to comply may
result in damage to equipment.
NOTE
Rear axle bogie components have very close
tolerances.
It may be necessary to seat
housing on shaft with a deadblow hammer
prior to tightening screws.
•
Acceptable bearing backlash is 0.002-0.012
in. (0.05-0.30 mm).
Failure to achieve
acceptable bearing backlash may result in
damage to equipment.
•
Housing must rotate by hand without binding.
Failure to comply may result in damage to
equipment.
NOTE
•
Use two pry bars to move housing on shaft
when measuring bearing backlash.
•
Record bearing backlash measurement.
Back to Top
