TM-9-2320-366-34-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4
AUGUST 2005
CHANGE 2
TM-9-2320-366-34-2 - Page 582 of 1434
TM 9-2320-366-34-2
10-30
Change 2
10-5.
INTERMEDIATE AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE
YOKE
REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Puller Kit, Universal (Item 51, Appendix B)
Wrench Set, Socket, (Item 84, Appendix B)
Driver, Intermediate Input Yoke Seal (Item 52,
Appendix D)
Multiplier, Torque Wrench (Item 42, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Driver, Intermediate Output Yoke Seal (Item 53,
Appendix D)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Socket, Socket Wrench (TM 9-2320-366-20)
Wrench, Impact, Electric (Item 88, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Sling, Cargo (Item 56, Appendix B)
Tools and Special Tools (Cont)
Driver, Intermediate Differential Output (Rear) Seal
(Item 50, Appendix D)
Driver, Differential Pinion Seal (Item 51, Appendix
D)
Pan, Drain (Item 43, Appendix B)
Holding Bar, Pinion (TM 9-2320-366-20)
Materials/Parts
Sealing Compound (Item 76.3, Appendix C)
Parts Kit, Seal Replacement (Item 313.4, Appendix
F)
Parts Kit, Seal Replacement (Item 313.5, Appendix
F)
Screw, Cap (4) (Item 366.1, Appendix F)
Nut, Self-Locking (Item 193, Appendix F)
Personnel Required
(2)
a.
Removal.
(1)
Lift tabs from two bearing cups (1).
(1.1) Remove four screws (2) and two bearing cups (1)
from drive yoke (3).
Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
(3) Attach drive shaft (4) to frame (6).
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
NOTE
Step (3) requires the aid of an assistant.
NOTE
There are two types of bearing cups, those
with tabs and those without tabs.
Perform
the following step on bearing cups with tabs.
Back to Top
