TM-9-2320-366-34-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4
AUGUST 2005
CHANGE 2
TM-9-2320-366-34-2 - Page 583 of 1434
TM 9-2320-366-34-2
Change 2
10-30.1/(10-30.2 Blank)
(4)
Remove drive yoke nut (7) from pinion shaft (8).
Discard drive yoke nut.
(5)
Place drain pan under pinion shaft (8).
(6)
Remove drive yoke (3) from pinion shaft (8).
(7)
Remove yoke seal (9) from drive yoke (3).
Discard
yoke seal.
(8)
Remove pinion seal (10) from intermediate
differential carrier (11).
Discard pinion seal.
b. Installation.
(1)
Apply a small amount of sealing compound to
outside edge and spring cavity of pinion seal (1).
(2)
Install pinion seal (1) in intermediate differential
carrier (2).
(3)
Visually verify pinion seal (1) is properly seated.
(4)
Install yoke seal (3) on drive yoke (4).
(5)
Install drive yoke (4) on pinion shaft (5) with drive
yoke nut (6).
(6) Tighten drive yoke nut (6) to 450-601 lb-ft (610-815
N•m).
NOTE
Input and output pinion and yoke seals and
drive yokes are removed the same way.
Input pinion and yoke seals and drive yoke
shown.
NOTE
Vehicles serial number 0001 through
3133, were not originally equipped with
yoke seals. Yoke seals may not be
present if maintenance has not been
previously performed on drive yoke.
NOTE
Input and output pinion and yoke seals and
drive yokes are installed the same way.
Input pinion and yoke seals and drive yoke
shown.
Back to Top
