TM-9-2320-386-24-1-2
2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 2 OF 2
MAY 2001
TM-9-2320-386-24-1-2 - Page 283 of 636
8.
Install clamp (2) on STE/ICE-R wiring harness (5), engine wiring harness (6), and firewall (4) with
screw (1) and new locknut (3).
9.
Install clamp (9) on STE/ICE-R wiring harness (5), engine wiring harness (6), and bracket (11) with
screw (10) and new locknut (8).
10.
Install tiedown straps (7) on wiring harnesses (5) and (6) as necessary to secure wiring harnesses.
11.
Install exhaust flex elbow (13) and new gaskets (15) and (16) on turbocharger (14) and inlet on
exhaust pipe (17) with two clamps (12).
12.
Install clamp (24) on STE/ICE-R wiring harness (5), engine wiring harness (32), and clamp (33) on
stud (29) with new locknut (34).
13.
If quick-start bracket (28) was removed, install quick-start bracket (28), new lockwasher (30), and
ground strap (31) on engine (27) with four new lockwashers (26) and screws (25).
14.
Install engine harness ground (GND) terminal (35), clamp (36) with STE/ICE-R wiring harness (5),
and engine wiring harness (32) on stud (23) with new lockwasher (37) and new locknut (38).
15.
Connect fuel pressure sender connector (39) to STE/ICE-R harness connector plug (40) with leads
770-F, 770-G, 770-U, and 770-V.
16.
Install wiring harness lead 54A (18) and STE/ICE-R terminal lead 770-R (19) on stud (20) with new
lockwasher (21) and nut (22).
1
2
3
4
~
9
8
7
5
6
11
~
10
TO STE/ICE-R SHUNT
TO FUEL PRESSURE
SENDER AND FUEL
SOLENOID
TO STARTER AND
ALTERNATOR
TM 9-2320-386-24-1-2
0331 00
STE/ICE-R WIRING HARNESS REPLACEMENT (Contd)
0331 00-10
Back to Top
