TM-9-2320-386-24-1-2
2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 2 OF 2
MAY 2001
TM-9-2320-386-24-1-2 - Page 310 of 636
TM 9-2320-386-24-1-2
0335 00
TRANSMISSION (IN-VEHICLE) REPLACEMENT (Contd)
0335 00-6
20.
Remove screw (2), lockwasher (1), ground strap (8), and lockwasher (9) from transmission (3) and
adapter (4). Discard lockwashers (1) and (9).
WARNING
Keep rear of transmission tilted slightly downward until two
retaining brackets can be installed to prevent converter from
separating from transmission and causing injury to personnel or
damage to equipment.
NOTE
Transmission has two screws installed where transmission lifting
fixture is installed. Remove screws from transmission and use
with fixture.
21.
Remove screw (5), clamp (6), and oil inlet hose (7) from adapter (4).
22.
Disconnect plug with leads 380 and 380A (16) from backup light switch (15).
23.
Install transmission lifting fixture on transmission (3) with two screws (11) and screw (10), and connect
sling in number two front hole and rear hole of transmission lifting fixture. Install sling to lifting
device.
WARNING
Install transmission jack under transmission when performing
steps 24 through 27 to support transmission and prevent injury to
personnel.
24.
Remove ten screws (2), lockwashers (1), and transmission (3) from adapter (4). Ensure rear of
transmission (3) is tilted slightly downward as transmission (3) is removed from adapter (4).
Discard lockwashers (1).
25.
Remove six screws (12) and ring (14) from torque converter (13).
NOTE
Check that converter has not moved forward before and after
installing retaining brackets. Measure distance from flat on
converter to lip on transmission housing. Distance cannot be more
than 1.5 in. (38 mm).
26.
Install two retaining brackets (19), one at 4 o’clock position and one at 8 o’clock position, on
transmission (3) and converter (13) with four washers (18) and (20) and screws (17) and (21).
27.
Remove twelve screws (23) and adapter (4) from flywheel housing (22).
SLING
TRANSMISSION
LIFTING
FIXTURE
1
2
4
3
2
1
8
5
7
3
~
10
11
6
4
9
Back to Top
