TM-9-2320-431-10-1
TRUCK, WRECKER, 8X8, M984A1
TECHNICAL MANUAL; OPERATOR'S MANUAL; PART 1 OF 2
JUNE 2009
TM-9-2320-431-10-1 - Page 1047 of 1244
OPERATOR MAINTENANCE
GROVE CRANE OPERATION (REMOTE CONTROL)
INITIAL SETUP:
Not Applicable
SET UP REMOTE CONTROL UNIT
WARNING
•
Do not operate crane unless outriggers are firmly in place or vehicle
could roll over. Failure to comply may result in injury or death to
personnel.
•
If operator cannot see load during operation, operate crane from
REMOTE CONTROL UNIT. Failure to comply may result in injury or
death to personnel.
•
When using crane on any vehicle, park vehicle clear of all overhead
electrical lines. Keep boom clear of all electrical lines and other
obstacles while operating crane. Failure to comply may result in injury
or death to personnel.
•
Excessive noise levels are present any time the heavy-duty winch or
crane is operating. Wear single hearing protection (earplugs or
equivalent) while working around equipment when it is running.
Failure to comply may result in injury or death to personnel. Seek
medical aid should you suspect a hearing problem. Failure to comply
may result in injury or death to personnel.
1.
Prepare crane for use. (WP 0106)
2.
Set up outriggers. (WP 0106)
3.
Jack outriggers. (WP 0106)
4.
Raise boom and mast to operating position. (WP 0106)
5.
Remove REMOTE CONTROL UNIT (1) and cable (2) from stowage box (3).
TM 9-2320-431-10-1
0107
0107-1
Back to Top
