TM-9-2320-434-10

TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-434-10 - Page 539 of 1324

LOADING - Continued

11.

Set transmission range selector (1) to N (neutral).

CAUTION

•

Ensure PARKING BRAKE control is pushed in (released) during load

sequence, or damage to equipment may result.

•

Do not use R (reverse) to back up vehicle while hook arm is attached

to flatrack, or damage to LHS will occur.

NOTE

No additional equipment can be stowed on or in FRS during loading/

unloading. Additional equipment could OVER LOADLHS due to weight

of FRS.

12.

Move joystick (7) to LOAD position to engage LHS lift hook (9) and flatrack hook bar

(2).

13.

If LHS lift hook (9) fails to engage flatrack hook bar (2):

a.

Release joystick (7).

b.

Set transmission range selector (1) to D (drive), release service brake pedal (3),

and move vehicle forward just clear of flatrack.

NOTE

LHS will only operate when transmission range selector is in N

(neutral).

c.

Set transmission range selector (1) to D (drive), release service brake pedal (3),

and move vehicle forward just clear of flatrack.

d.

Repeat Steps (9) through (12).

NOTE

•

If NOT loading a forward repair system, skip to Step (15).

•

No additional equipment can be stowed on or in FRS during loading.

Additional equipment could OVER LOAD LHS due to weight of FRS.

14.

If loading a forward repair system (FRS) complete the following steps:

CAUTION

Engine speed must be at idle before using hydraulic selector switch,

or damage to equipment may result.

a.

Turn hydraulic selector switch (6) to MAN H.A.

TM 9-2320-434-10

0065

0065-7