TM-9-2320-434-10
TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-434-10 - Page 541 of 1324
LOADING - Continued
CAUTION
Engine speed must be at idle before using hydraulic selector switch,
or damage to equipment may result.
d.
Turn hydraulic selector switch (6) to MAN M.F.
e.
Continue with Step (15).
WARNING
Prior to and during any load or unload cycle, all personnel should stay
clear of LHS, flatrack, front lift adapter, and container. Failure to comply
may result in injury or death to personnel.
WARNING
When loading or unloading flatracks/FRS on uneven ground (side slope
or downgrades up to 5 degrees), it may be necessary to apply vehicle
service brakes to prevent vehicle rollaway. Failure to comply may result
in injury or death to personnel.
CAUTION
•
If LHS OVER LOADindicator illuminates but loading operation
continues, operator is cautioned that LHS is nearing maximum
capacity. In this situation, operator should determine if payload is
evenly distributed on flatrack or if flatrack load exceeds 25,000 lbs
(11 350 kg) for LHS or 24,000 lbs (10 896 kg) for LHS with CHU kit.
If any of these conditions exist, operator must redistribute or reduce
payload or damage to equipment may result.
•
Ensure that PARKING BRAKE control is pushed in (released) before
starting load sequence, or damage to equipment may result.
•
When loading or unloading FRS, engine speed must be at 1500 rpm.
15.
Move joystick (7) to LOAD position, allowing vehicle to be pulled under flatrack.
TM 9-2320-434-10
0065
0065-9
Back to Top
