TM-9-2320-434-10

TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-434-10 - Page 576 of 1324

OPERATION - Continued

10.

Set transmission range selector (2) to R (reverse), release service brake pedal (11),

and back vehicle up until LHS lift hook (9) contacts flatrack hook bar (10).

WARNING

Prior to and during any load or unload cycle, all personnel should stay

clear of LHS, flatrack, front lift adapter, and container. Failure to comply

may result in injury or death to personnel.

WARNING

When loading or unloading flatracks/FRS on uneven ground (side slope

or downgrades up to 5 degrees), it may be necessary to apply vehicle

service brakes to prevent vehicle rollaway. Failure to comply may result

in injury or death to personnel.

NOTE

LHS will only operate when transmission range selector is in N (neutral).

11.

Set transmission range selector (2) to N (neutral) and apply service brake pedal (11).

NOTE

The amount of time to load and unload is controlled by engine speed.

Engine speed may be increased to approximately 1,500 rpm to reduce

loading and unloading times.

12.

Move joystick (8) to UNLOAD position and engage LHS lift hook (9) into flatrack hook

bar (10).

13.

Pull out PARKING BRAKE control (1).

14.

Check that trailer bumper (13) is under flange and within 3.5 in. (89 mm) from vehicle

bumper stop (14).

TM 9-2320-434-10

0067

0067-6