TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 90 of 1616
TM 9-2320-440-13&P
0013-4
0013
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
WARNING
Keep clear of hydraulic cylinders during operation. Failure to comply may result in
injury to personnel.
NOTE
•
Left and right outrigger stabilizer (STABILIZER LH and STABILIZER RH) control levers
can be operated independently or at the same time.
•
Outrigger stabilizer movement from one lever may be slower than the other when
operating two levers together.
•
Air suspension will automatically deflate when outriggers are deployed.
•
Position of outrigger pad may need adjustment so outrigger stabilizer cylinder rod will
lower into outrigger pad socket.
•
Always operate control levers with light, even pressure.
16.
Push and hold palm button switch (9).
17.
Move STABILIZER LH control lever (15) and STABILIZER RH control lever (16) control levers to DOWN
position to lower outrigger stabilizer cylinder rods (13) until rod ends are seated in outrigger pads (7).
18.
Release palm button switch (9).
19.
Install two retaining pins (14) in each outrigger pad (7).
WARNING
Do not raise vehicle tires off ground with outrigger stabilizers. Always chock front
wheels when using outriggers. Failure to comply may result in injury or death to
personnel and/or damage to equipment.
20.
Push and hold palm button switch (9).
21.
Move STABILIZER LH control lever (15) and STABILIZER RH control lever (16) to DOWN position.
Lower outrigger stabilizer cylinder rods (13) until height of vehicle increases by approximately 4 in. (10.2
cm).
22.
Release palm button switch (9).
THAAD0199
Back to Top
