TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 240 of 576

4-154

TM 99-2330-227-14&P

LANDING GEAR HANDCRANK

This task covers:

a. Removal (page 4-154)

b. installation (page 4-154)

INITIAL SETUP

Tool s

Personnel Required

Handle, ratchet, 1/2-inch drive

One

Socket, 1/2-inch drive, 9/16-inch

Wrench, box-end, 9/16-inch

ACTION

LOCATION

ITEM

REMARKS

NOT E

Both landing gear handcranks are removed and installed the same way. This task is for

one; repeat for the other.

REMOVAL

1.

Shaft (1) and

Screw (3), nut (4),

Using 9/16-inch socket, ratchet handle

crank (2)

and two washers (5)

with 1/2-inch drive, and 9/16-inch box-

end wrench, unscrew and take out.

2.

Shaft (1)

Crank (2)

Take off.

INSTALLATION

3.

4.

Shaft (1) and

crank (2)

Crank (2)

Put on.

Screw (3), nut (4),

Screw in, and tighten using 9/16-inch

and two washers (5)

socket, ratchet handle with 1/2-inch

drive, and 9/16-inch box-end wrench.