TM-9-2330-238-14
CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1992
TM-9-2330-238-14 - Page 344 of 462
TM
9-2330-238-14
5-14.
LANDING
GEAR
ACTUATING
LEG ASSEMBLY
REPAIR
(EARLY MODEL)
(Con’t).
12.
13.
14.
15.
16.
17.
Install two plugs
(2) in end of outer leg assembly (3),
with first plug against
flat surface
of inner leg (31). The inner
plug should
be loose
enough
to allow
the inner leg to move in and out freely,
but tight
enough
to keep
in from
rotating.
Start drive shaft (5) through
opening
in outer leg (3) and install woodruff
key (17), bevel gear (18), and flat washer
(10) on drive
shaft.
Push drive shaft (5) in outer leg assembly (3)
so approximately
same length of the shaft extends
on each side of
outer
leg assembly.
Install one new spring pin (6) to secure
bevel gear (18), then install other new spring
pin (6) against
washer
(10).
Lubricate
bevel gears (9 and 18) and bearings
(8 and 21) in accordance
with Lubrication
Instructions
(Chapter
3,
Section
I).
Install new gasket
(12) and access
cover
(13) on top of outer leg (3) with two screws (14)
and two screws
(15).
FOLLOW-ON
TASKS:
●
Install
and adjust
landing
gear
(para 5-11).
5-42
Back to Top
