TM-9-2330-247-14-P
CHASSIS, TRAILER: GENERAL PURPOSE, 3-1/2 TON, 2-WHEEL, M353
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
MARCH 1992
TM-9-2330-247-14-P - Page 130 of 320
TM 9-2330-247-14&P
4-37.
HYDRAULIC TUBES AND FITTINGS (Con’t)
ACTION
LOCATION
ITEM
REMARKS
10.
Nut (15) and
hydraulic
tube (9)
11.
Nut (15) and
bracket (14)
12.
Bracket (14)
13.
Tee fitting (19)
and hydraulic
tube (16)
14.
Tee fitting
(19) and
bracket (14)
INSTALLATION
Nut (11)
Using X6 in. and I%G in. open-end box wrenches,
unscrew.
Nut (12)
Using
~ in. and l%G in. open-end box wrenches,
unscrew.
Take off.
Nut (12) and
Iockwasher (13)
Nut (17)
Using % in. open-end box wrench, unscrew and take
off.
Hydraulic tube
(16) and gasket
(18)
Take off.
Put in place
15.
16.
17.
18.
19.
20.
21.
22.
Hydraulic tube
(16) and gasket
(18)
Screw into tee fitting (19) and tighten using
~ in.
open-end box wrench.
Hydraulic tube
(16) and tee
fitting (19)
Nut (17)
Bracket (14)
Nut (15)
Put in place.
Nut (15)
Lockwasher (13)
and nut (12)
Screw in and tighten using l%G in. and % in. open-
end box wrenches.
Bracket (14)
Hydraulic tube (9)
Put in place.
Hydraulic tube (9)
and nut (15)
Nut (11)
Screw in and tighten using ZG in. and l~e in. open-
end box wrenches.
Hydraulic tube
(9)
Four clamps (20)
a. Locate screw holes in frame.
b. Put clamps (20) on hydraulic tube (9) opposite
holes.
Hydraulic tube (8) on right side has only
two clamps (10).
Four clamps
(20)
Four screws (21),
Iockwashers (22),
and nuts (23)
Screw in and tighten using no. 2 cross-tip
screwdriver and Xfj in. open-end box wrench.
For left side only, mounting hardware for
three clamps (20) also holds chassis
wiring harness clamps. Hydraulic tube (8)
on right side has only two clamps (10) and
they do not mount with harness clamps.
4-76
Back to Top
