TM-9-2330-247-14-P
CHASSIS, TRAILER: GENERAL PURPOSE, 3-1/2 TON, 2-WHEEL, M353
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
MARCH 1992
TM-9-2330-247-14-P - Page 123 of 320
TM 9-2330-247-14&P
4-35.
MASTER CYLINDER (Con’t)
ACTION
LOCATION
ITEM
REMARKS
Twist off.
Pull off.
7.
Tube (1)
8.
9.
Tube (1) and
master cylinder (5)
10.
Master cylinder (5)
11.
12.
Master cylinder (5)
13.
Master cylinder (5)
INSTALLATION
Hose (4)
Clamp (2) and
screw (3)
Nut (19) and
filler cap (18)
Using
~ in. open-end box wrench and 1 in. open-end
wrench, unscrew nut (19) from filler cap (18).
Take off.
Using 1 in. open-end wrench, unscrew and take off.
Using
~ in. flat-tip screwdriver, pry out.
Take off.
Tube (1)
Filler cap (18)
Gasket (17)
Boot (15) and
retaining clip (14)
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
Boot (15) and
retaining clip (14)
Put on.
Gasket (17)
Put in position.
Filler cap (18)
Using 1 in. open-end wrench, screw in and tighten.
Tube (1)
Put in position.
Tube (1) and
master cylinder
(5)
Tube (1)
Nut (19) and
filler cap (18)
Using
~ in. open-end box wrench, screw nut (19)
into filler cap (18) and tighten.
Hold tube (1) to stop it from turning.
Slide up around tube (1).
Clamp (2) and
screw (3)
Hose (4)
Twist on.
a. Slide down clamp (2) until it fits over hose (4)
and tube end.
b. Using ~ in. flat-tip screwdriver, tighten screw (3)
until clamp (2) is snug.
Do not overtighten or clamp (2) will cut
hose (4).
Tube (1) and
hose (4)
Clamp (2) and
screw (3)
a. Using
~ in. socket and ratchet handle with
x in.
drive, screw in and tighten.
b. Take master cylinder (5) out of vise.
Master cylinder
(5)
Airbrake chamber
studs (16)
Straight adapter (10)
and washer (11 )
Master cylinder (5)
Put into position.
Three
Iockwashers (13)
and nuts (12)
Screw and tighten using XG in. socket, ratchet
handle with
~ in. drive, and extension.
4-69
Back to Top
