TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 129 of 640
0016-11
TM 9-2330-335-14&P
0016
21
Triennial or
Every 36,000
Miles
ABS Sensors
CAUTION
Push sensor to tone ring using a
wooden rod or by hand. Sensor
should be pushed against tone ring
and will self-adjust in use. A gap
of
0.040 in.
(1.02
mm)
is
allowable. Excessive gap may
cause diagnostic fault.
Check that sensor pick-ups are lightly
touching tone ring, or have a gap of no
more than 0.040 in. (1.02 mm) between
the tone ring and pick-up end.
22
Triennial or
Every 36,000
Miles
Brake Systems a. Check brake lining thickness, springs,
anchor pins, bushings, and rollers for
damage and wear.
Linings are worn to limit.
Springs, anchor pins, bushings,
and rollers are damaged or worn.
WARNING
Do not allow brake lining to wear
to the point that the rivets touch
the drum. This condition can cause
brake failure, injury to personnel,
and damage to equipment.
CAUTION
To ensure a balanced braking sys-
tem, both brake assemblies on an
axle end should have like repairs
accomplished at the same time.
Failure to comply could cause
damage to equipment.
b. See WP 0067 for lubrication points.
23
Triennial or
Every 36,000
Miles
S-Cams
Check for wear and damage to spline,
bushings, cam lobes, and retaining
brackets. Replace bushings.
Damage/wear affects operation.
Table 1. Organizational Preventive Maintenance Checks and Services (PMCS) - Continued.
ITEM
NO.
INTERVAL
MAN-
HOURS
LOCATION
ITEM TO
CHECK/
SERVICE
PROCEDURE
NOT FULLY MISSION
CAPABLE IF:
Back to Top
