TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 127 of 640
0016-9
TM 9-2330-335-14&P
0016
13
(Con’t)
Semiannual
or Every
6,000 Miles
Studs and
Flange Nuts
b. Flange nut torque:
Torque flange nuts to 50 lb-ft
(67.8 Nm) and then tighten to 450 to
500 lb-ft (610 to 678 Nm) using
DRY torque.
c. Torquing sequence is as follows:
Using DRY torque for flange nuts and
studs, facing wheel, clockwise sequence
starting at top (WP 0097).
14
Semiannual
or Every
6,000 Miles
Automatic
Slack
Adjusters
(ASAs)
CAUTION
• Do not use air or electric tools to
adjust ASAs.
• Initial adjusting procedures start
with measurements, not teardown.
• Failure to comply could cause
damage to equipment.
Check for any binding, broken, worn or
loose parts, missing hardware, evidence
of an out-of-adjustment condition, worn
clutch, and release action.
Binding, wear, loose parts,
missing hardware, out-of-
adjustment conditions
are evident.
15
Annual or
Every 12,000
Miles
Axles
Check axles for proper alignment (refer to
WP 0111 and TB 9-2510-242-40, Nov 95,
pages 21 to 25). If suspension is damaged,
notify Direct Support Maintenance.
Axles are not in alignment.
16
Annual or
Every 12,000
Miles
Wood Decking
Corrosion
Apply a thin coat of UV wood or
linseed oil protector to upper and
lower deck surfaces.
Board(s) are broken or missing.
Table 1. Organizational Preventive Maintenance Checks and Services (PMCS) - Continued.
ITEM
NO.
INTERVAL
MAN-
HOURS
LOCATION
ITEM TO
CHECK/
SERVICE
PROCEDURE
NOT FULLY MISSION
CAPABLE IF:
Back to Top
