TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 117 of 640
TM 9-2330-335-14&P
0015-1
0015
ORGANIZATIONAL MAINTENANCE
-
ORGANIZATIONAL PMCS INTRODUCTION
GENERAL
00015
1.
To ensure that the semitrailer is ready for operation at all times, it must be inspected on a regular basis so that
defects may be found and corrected before they result in injury, damage, or equipment failure.
2.
The PMCS Table in WP 0016 contains systematic instructions on inspections, lubrications, services, tests, and corrections
to be performed by Organizational Maintenance to keep your equipment in good operating condition and ready for its
primary mission.
EXPLANATION OF TABLE ENTRIES
00015
1.
Item No. Column.
Numbers in this column are for reference. When completing DA Form 2404 or DA Form
5988-E
(Equipment Inspection and Maintenance Worksheet)
, include the item number for the check/service
indicating a fault. Item numbers also appear in the order that you must perform checks and services for the
interval listed.
2.
Interval Column.
This column tells you when you must perform the procedure in the Procedure column:
a.
Monthly
procedures must be done once each month.
b.
Semiannual
procedures must be done once every 6 months.
c.
Annual
procedures must be done once each year.
d.
Triennial
procedures must be done once every 3 years.
e.
Mileage
procedures must be done at the intervals specified.
3.
Item to Check/Service Column.
This column lists the item to be checked or serviced.
NOTE
The WARNINGs and CAUTIONs appearing in your PMCS table should always be observed.
WARNINGs and CAUTIONs appear before applicable procedures. You must observe these
WARNINGs to prevent injury or death to yourself and others, and CAUTIONs to prevent your
equipment from being damaged.
4.
Procedure Column.
This column gives the procedure you must perform to check or service the item listed in the Item to
Check/Service column, to know if the equipment is ready or available for its intended mission. You must perform the
procedure at the time stated in the interval column.
5.
Not Fully Mission Capable If: Column.
Information in this column tells you what faults will keep your equipment from
being capable of performing its primary mission. If you perform check/service procedures that show faults listed in this
column, the equipment is not mission-capable. Follow standard operating procedures for maintaining the equipment or
reporting equipment failure.
2
Back to Top
