0014-10
TM 9-2330-335-14&P
0014
22
During
ABS Warning
Light
NOTE
• If ABS warning light stays on
during mission, continue on with
mission until system can be
properly diagnosed by
Organizational Maintenance.
Braking capacity will not be
impaired. The only effect will be
no modulation at wheel or wheels
that have a fault.
• Trailer is not NMC if during
mission ABS is inoperable and
there is no time to diagnose
problem(s).
• During blackout mode conditions,
tape over ABS warning light. Do
not remove or otherwise disable
light.
Check that ABS warning light does not
stay on.
23
During
Axles and
Suspension
Listen for unusual noises, which are
indications of possible problems. Be alert
to conditions such as side pull,
wandering, tracking of semitrailer, and
load shift.
Unusual noises, semitrailer
wanders, pulls to either side, or
does not track.
24
During
General
Be alert to all conditions that may indicate
unsafe operation or improperly secured
cargo. Ensure all prime mover TM
procedures are adhered to for safe
operation, i.e., coupling load limits,
speeds, and fifth wheel settings for on/off
road operation.
Unsafe conditions are identified.
25
After
Landing Leg
Assembly
CAUTION
Do not use high-speed cranking
mode for lifting and lowering of
landing gear if there is a load on
the semitrailer. Failure to comply
could cause damage to equipment.
Table 1. Operator Preventive Maintenance Checks and Services (PMCS) - Continued.
ITEM
NO.
INTERVAL
MAN-
HOURS
LOCATION
ITEM TO
CHECK/
SERVICE
PROCEDURE
NOT FULLY MISSION
CAPABLE IF: