TM-9-2330-335-14-P

SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)

SEPTEMBER 2008

TM-9-2330-335-14-P - Page 535 of 640

0094-1

TM 9-2330-335-14&P

0094

FIELD AND SUSTAINMENT MAINTENANCE

-

LANDING GEAR OPERATING, MAINTENANCE, AND REPAIR PROCEDURES

Operation of Holland Formula 150 Landing Gear, Remove Tractor from Semitrailer,

Connect Tractor to Semitrailer, Lubrication,

Troubleshooting, Alignment

NOTE

Do not deviate from these instructions. Any changes or deviations will void all warranties,

expressed or implied, unless written consent is first obtained from the factory.

OPERATION OF HOLLAND FORMULA 150 LANDING GEAR

00094

WARNING

Ensure the landing leg scissor assembly retaining (locking) pins do not present a contact hazard to

personnel. The pins can extend outward and cause injury to personnel.

CAUTION

•

Always grip crank handle securely with both hands before shifting.

•

Never shift landing gear under load.

•

Never leave the crank unsecured.

•

Never raise or lower a loaded trailer in high gear.

•

Failure to comply could cause damage to equipment.

NOTE

Holland Formula 150 2-speed gearbox has high- and low-range gears. High-range gear is to be

used only for rapid traverse up from and down to the ground and is not intended to lift or lower

any load. For additional information, see Holland publication XL-FW302-XX,

Fifth Wheel

Operating Instructions

.

Extend

00094

On outside-mounted landing gear, engage the crank with the crankshaft and turn the crank clockwise. Inside-mounted landing

gear are extended by turning the crank counterclockwise. Using high gear, lower the landing gear until the pads make contact

with the ground. To reduce the load on the fifth wheel, shift to low gear and crank an additional four to eight turns. Leave the

landing gear in low gear and store the crank handle in the holder provided.

6