0096-1
TM 9-2330-335-14&P
0096
FIELD AND SUSTAINMENT MAINTENANCE
-
SEALED BRAKE INSTALLATION AND DISARMING
General Safety Precautions, Mechanical Release of Spring Brake (Gold Seal),
Combination Spring Brake Installation Instructions,
Disarming Introduction, Disarming Instructions, Supplementary Information
GENERAL SAFETY PRECAUTIONS
00096
WARNING
•
A spring brake contains a very powerful compression spring. Failure to comply with all of the
following instructions may result in forceful release of the piggyback or spring chamber and its
contents which could cause death, severe personal injury and/or property damage.
•
ALWAYS BLOCK WHEELS to prevent vehicle roll-away when performing any
brake maintenance.
1.
If spring brake shows structural damage, DO NOT cage the spring and DO NOT attempt to service it. Replace
the complete unit. To prevent severe personal injury when removing an uncaged spring brake from a vehicle, cut
the service push rod making sure to relieve all force on it. After cutting the push rod, remove the spring brake
from the vehicle, then disarm the spring brake using a suitable safety chamber (see
Disarming Introduction
and
Disarming Instructions
in this work package).
2.
Never strike any part of the spring brake with a hammer or any other heavy object; structural damage may result.
3.
Do not drop spring brake, as compression spring may forcefully release.
4.
If air pressure is used to aid in the caging process, do not tighten the release tool more than finger tight. The air pressure
must always be exhausted after the spring has been mechanically caged prior to disassembly.
20