TM-9-2330-342-10
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; OPERATOR'S MANUAL
SEPTEMBER 2012
TM-9-2330-342-10 - Page 137 of 500
Preparation For Loading - Continued
NOTE
•
When loading flatrack without rollers, perform Steps (a) and
(b).
•
Ensure surface plates are returned to stowage after flatrack
has been unloaded from trailer.
a.
Remove two surface plates (Figure 2, Item 3) from stowage box.
b.
Position two surface plates (Figure 2, Item 3) on trailer (Figure 2, Item 4) in
flatrack locks (Figure 2, Item 1) opening.
NOTE
There must be sufficient air pressure in trailer air system to retract flatrack
locks. If not, charge the air system (WP
0022). If air system cannot retract
flatrack locks, manually retract flatrack locks (WP
0015).
5.
As flatrack is loaded, inspect and verify trailer guides (Figure 3, Item 1) are lined up
between flatrack main rails (Figure 3, Item 2).
1
2
Figure 3.
Preparation for Loading.
6.
Refer to vehicle Operator's manual (WP
0057) for flatrack loading procedures.
7.
When flatrack is completely loaded, make certain that rear rollers (Figure 4, Item 3)
have contacted rear trailer stops (Figure 4, Item 1).
TM 9-2330-342-10
0018
0018-3
Back to Top
