TM-9-2330-342-10
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; OPERATOR'S MANUAL
SEPTEMBER 2012
TM-9-2330-342-10 - Page 133 of 500
Release Parking Brake - Continued
NOTE
•
If caging bolt cannot be pulled directly out, it is properly inserted.
•
Spring is fully compressed when caging bolt is sticking out
approximately 3.0 in. (76.2 mm).
6.
Install nut (Figure 2, Item 1) and washer (Figure 2, Item 3) on caging bolt (Figure 2,
Item 2). Tighten nut (Figure 2, Item 1) until spring is fully compressed.
7.
Repeat Steps (2) through (5) for the other brake chambers.
WARNING
Trailer must be connected to vehicle with parking brakes set before
removing chock blocks or trailer may move uncontrolled. Failure to
comply may result in injury or death to personnel.
8.
Remove chock blocks from trailer wheels (WP
0020).
END OF TASK
Apply Parking Brakes
WARNING
Trailer wheels must be chocked while caging brake chambers. Failure to
comply may result in injury or death to personnel.
1.
Chock wheels of trailer (WP
0020).
1
2
5
4
3
Figure 3.
Apply Parking Brake.
TM 9-2330-342-10
0017
0017-3
Back to Top
