TM-9-2330-342-10
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; OPERATOR'S MANUAL
SEPTEMBER 2012
TM-9-2330-342-10 - Page 224 of 500
BUMPER TO FLATRACK MODE - Continued
WARNING
Hands may get pinched if cart pivot bracket falls while removing pin.
Support cart pivot bracket while removing pin to avoid pinching fingers
between trailer and cart pivot bracket. Failure to comply may result in
injury to personnel.
5.
Rotate cart pivot bracket (Figure 60, Item 6) down.
6.
Install hitch pin (Figure 60, Item 4) in cart pivot bracket (Figure 60, Item 6).
7.
Install lynch pin (Figure 60, Item 3) in hitch pin (Figure 60, Item 4).
CAUTION
After lynch pins and hitch pins are removed, set lynch pins and hitch pins
on top of trailer so they are not hanging down. Failure to comply may
result in damage to equipment.
8.
Repeat Steps (1) through (7) for right side cart pivot bracket.
9.
Attach cart loading sling (Figure 61, Item 1) in two rear most holes on cart bracket
(Figure 61, Item 2).
TM 9-2330-342-10
0025
0025-66
Back to Top
