TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 1020 of 1348

BEARING LUBRICATION

Lubricate bearings before assembly with lubricant used in the related housing or container to provide the first run-

in until lubricant from the system can reach the bearings.

END OF TASK

SILICONE SEALANT

WARNING

On direct contact, uncured silicone sealant irritates eyes. Wear proper eye protection and

gloves. If silicone sealant gets in your eyes, flush eyes with water and seek immediate medical

attention. In case of skin contact, wipe off skin and flush with water. Failure to comply may

result in injury or death to personnel.

Silicone sealant is often used instead of a gasket to seal mating parts. The mating parts must be clean, dry, and free

of oil or grease for proper adhesion. After silicone sealant has been applied, the mating parts must be assembled

immediately. Silicone sealant starts to set up in 15 minutes and takes 24 hours to completely set. Excess silicone

sealant should be wiped off after assembling the mating parts.

END OF TASK

GASKETS

Remove all traces of previous gasket and sealant before installing new gasket. Coat both sides of gasket with sealant

to provide added sealing.

END OF TASK

END OF WORK PACKAGE

TM 9-2330-342-23&P

0126

0126-2