TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 128 of 1348

5.

Perform ICE Test 91.

6.

Meter should display a reading less than 200 ohms.

CONDITION/INDICATION

Is continuity measured across wire 1012B between diode assembly connector, terminal 5 and rear junction box?

DECISION

Yes - Replace diode assembly (WP

0059). Go to (Step 8 - Do front side markers lights, rear side marker lights, and

rear marker lights operate?) to verify problem is solved.

No - Go to (Step 7 - Can trailer main harness wire 1012B be repaired?).

STEP 7

Can trailer main harness wire 1012B be repaired?

WARNING

Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around vehicle.

Jewelry and tools can catch on equipment, contact positive electrical circuits, and cause a

direct short, severe burns, or electrical shock. Failure to comply may result in injury or death

to personnel.

NOTE

Wire is not repairable if damage cannot be visually located or if a prior repair has already

reduced length of wire. Wire is not repairable if after repair, wire is too short to reach its

connection point.

1.

Visually check if trailer main harness wire 1012B can be repaired.

TM 9-2330-342-23&P

0006

0006-8