TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 135 of 1348

5.

Meter should display a reading less than 200 ohms.

CONDITION/INDICATION

Is continuity measured between 12 vdc cable connector, pin A and a known good ground?

DECISION

Yes - Go to (Step 4 - Can trailer main harness wire 1435 be repaired?).

No - Go to (Step 3 - Can 12 vdc cable be repaired?).

STEP 3

Can 12 vdc cable be repaired?

1.

Have assistant turn OFF lights. Refer to vehicle Operator's manual (WP

0190).

WARNING

Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around vehicle.

Jewelry and tools can catch on equipment, contact positive electrical circuits, and cause a

direct short, severe burns, or electrical shock. Failure to comply may result in injury or death

to personnel.

NOTE

Wire is not repairable if damage cannot be visually located or if a prior repair has already

reduced length of wire. Wire is not repairable if after repair, wire is too short to reach its

connection point.

2.

Have assistant turn engine start switch to OFF. Refer to vehicle Operator's manual (WP

0190).

3.

Disconnect 12 vdc (7 pin) cable from vehicle.

TM 9-2330-342-23&P

0007

0007-3