TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 311 of 528

TM 9-2330-356-14

Table 5-2. Fabricated Tools and Equipment (Con‘t).

Sketch or Diagram:

Table 5-3. Fabricated Tube Lines.

Part No.

Bulk Part No.

Bulk Tubing Dia.

11670916-1

CPR 104420-1

1/4“

60”

11670916-2

CPR 104420-2

3/8“

60"

11670916-3

8360440

5/8”

40"

Section II.

5-4.

General

a.

This

section

DIRECT SUPPORT AND GENERAL SUPPORT TROUBLESHOOTING

contains

troubleshooting

information for locating and correcting most of the

troubles which may develop in the semitrailers. Each

malfunction for an individual component, unit, or system

is followed by a list of tests or inspections which will help

you to determine corrective actions to take. You should

perform the test/inspections and corrective actions in the

order listed.

b.

This manual cannot list all malfunctions that may

occur, nor all tests and inspections and corrective actions.

If a malfunction is not listed or is not corrected by listed

corrective actions, notify your supervisor.

c.

Ensure that all safety precautions listed in the

Warning Summary are

followed while performing

troubleshooting. Pay close attention to all WARNINGS

and CAUTIONS.

5-5.

Use

a.

Information in this section is for use by direct

support and general support personnel.

b.

Tables 5-4 and 5-5 are to be used in conjunction

with and as a supplement to Operator Troubleshooting

(table 3-2) and Unit Troubleshooting (table 4-9), located

elsewhere in this manual.

5-6.

Procedures and Instructions

NOTE

Before you use the troubleshooting tables,

ensure that you have performed all applicable

operational checks.

a.

Tables 5-4 and 5-5 include procedures for

on-equipment tests and inspections, and for testing the

component or assembly after it has been removed from

the semitrailer.

5-3