TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990
TM-9-2330-356-14

  TM-9-2330-356-14 - Page 301 of 528

Figure 4-159. Static Reel.
c.
Replacement of Electrical Clip.
Remove screw and
nut that attaches clip to cable, then remove clip. Remove
screw and nut from new clip and replace securing cable
between head of screw and clip.
4-97. Vehicle Nozzle (M969 and M969A1)
a.
Removal.
(1) Pull hose reel hose out far enough to work on
nozzle easily.
(2) Unscrew nozzle from end of hose.
(3) If reducer is removed with nozzle, unscrew
bushing and screw back into hose.
b.
Installation.
Screw nozzle into reducer bushing on
end of hose. Tighten securely. Rewind hose reel hose
(para 2-11).
4-98. Vapor Recovery Piping (Fig. 4-160)
a.
Replacement of Vapor Recovery Hood and Hose.
(1)
Removal.
(a)
Loosen clamp (6) and remove hood (7).
TM 9-2330-356-14
(b)
Loosen hose clamp (1) and slide off hose
and hood as a unit.
(c)
Loosen hose clamps (2) and (4), and
remove hose (3) and pipe (5).
(d)
Loosen clamp (8) and remove plug (9).
(2)
Installation.
(a)
Reverse instructions in step (1).
b.
Replacement of Piping.
(1)
Removal.
(a)
Remove coupling (10) from coupling
(11).
(b)
Remove two nuts and bolts from coupler
(12) and remove coupler.
(c)
Provide support for pipe assembly (16) so
it will not fall.
(d)
Remove four nuts (13), four washers
(14), and two U-bolts (15). Remove pipe assembly (16).
(e)
Remove coupling (11) from pipe.
(f)
Remove eight capscrews (17) and nuts
(18).
(g)
Remove vent (19) and gasket (20).
(2)
Installation.
Install pipe in reverse order of
removal steps
(a)
through
(g).
When installing coupling
(12), refer to paragraph 4-85.
c.
Replacement of Ground Receptacle.
(1)
Removal.
(a)
Remove ground wire from tool box by
removing screw and nut.
(b)
Remove two screws (21, fig. 4-160) and
nuts (22) and remove receptacle (23).
(c)
If bracket (24) is to be removed, remove
two capscrews (25) and nuts (26), and remove bracket (24).
(2)
Installation.
Install ground receptacle by
reversing steps
(a)
through
(c).
4-165


Back to Top