TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 463 of 528

TM 9-2330-356-14

Section VII. NOZZLES AND COUPLINGS

8-22. Vehicle Nozzle (M969 and M969A1)

a.

Removal.

Remove nozzle (para 4-96).

b.

Disassembly (Fig. 8-28).

(1)

(2)

(3)

nozzle.

(4)

remove the

Place nozzle assembly on a clean work area.

Unscrew ground wire from nozzle handle.

Disconnect the chain for the cap from the

Unscrew the spout from nozzle handle and

strainer.

c.

Cleaning and Inspection.

WARNING

Dry cleaning solvent P-D-680 is toxic and

flammable. Always wear protective goggles

and gloves, and use only in a well-ventilated

area. Avoid contact with skin, eyes, and

clothes, and DO NOT breathe vapors. DO

NOT use near open flame or excessive heat.

The solvent’s flash point is 100°F-138°F

(38°C-59°C). If you become dizzy while

using cleaning solvent, immediately get fresh

air and medical help. If solvent contacts eyes,

immediately wash your eyes with water and

get medical aid.

(1) Clean the strainer, spout, and nozzle handle

with dry cleaning solvent (item 11, Appendix E) and dry

thoroughly.

(2) Check spout, screen, rubber cap and chain,

and ground wire and connector for damage.

(3) Replace any damaged part.

d.

Assembly (Fig. 8-28).

(1) Insert strainer into spout and screw spout

onto handle.

(2) Reconnect cap and chain to the nozzle.

(3) Screw ground wire into nozzle handle.

e.

Installation.

Install vehicle nozzle to hose

(para 4-96).

TA223050

Figure 8-28. Vehicle Nozzle (M969 and M969A1).

8-23. Overwing Nozzle (M970 and M970A1)

a.

Removal.

Remove overwing nozzle (para 3-15).

b.

Disassembly (Fig. 8-29).

(1)

(2)

(3)

nozzle.

(4)

Place nozzle assembly on a clean work area.

Unscrew ground wire from nozzle handle.

Disconnect the chain for the cap from the

Unscrew the spout from nozzle handle and

remove the strainer.

(5) Loosen thumb screw and slide protector ring

off end of spout.

8-33