TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 1035 of 1364

TM 9-2350-238-20-1

2-175. MAINTENANCE OF HEATER INSTALLATION KIT—BATTERY

COVERS.

BOX AND

This task covers:

a.

Removal

b.

Inspection/Repair

c.

Installation

INITIAL SETUP

Materials/Parts

General Safety Instructions

Cotter pin (4)

References

TM 9-2350-238-24P-1

Disconnect ground leads first and

connect ground leads last when

Equipment Conditions

removing or installing electrical leads.

Master switch in OFF position

1

2

3

4

5

6

7

Remove battery insulation pad (1).

Disconnect both ground leads first

when removing electrical leads from

batteries.

Remove ten hexagon plain nuts (2), ten

flat washers (3), two battery holddown

plates (4), and three battery retaining

plates (5).

Remove four cotter pins (6), four flat

washers (7), four headed straight pins (8),

and four battery holddown rod end

connectors (9) from battery box (10).

Remove batteries. Refer to page 2-840.

Remove three plate assembly anchors

(11) from battery box (10).

Remove eight hexagon head capscrews

(12), eight flat washers (13), and battery

heating pad (14) from battery box (10).

Remove battery box (10) from vehicle.

2-1009