TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 673 of 1364

TM 9-2350-238-20-1

c.

Untag and connect shell connector to line connection.

d.

Untag and connect shell connector to instrument switch (5).

e.

Untag and connect shell connector to master switch (6).

f.

Untag and connect shell connector to infrared receiver switch (7).

3

Untag and connect three shell connectors (8) to line connections.

4

Untag and connect shell connector (9) to dome light assembly (10).

5

Connect plug connector (11) to bulkhead disconnect.

6

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-89. MAINTENANCE OF BULKHEAD DISCONNECT TO ENGINE COMPONENTS AND

WARNING UNITS BRANCHED WIRING HARNESS.

This task covers:

a.

Removal

d.

Reassembly

b.

Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Materials/Parts

General Safety Instructions

Electrical wire (figure D-2, appx D)

References

TM 9-2350-238-24P-1

Failure to remove or disconnect

batteries before removing or installing

Equipment Conditions

any

electrical wiring harness or lead

2-640 Batteries disconnected

may result in injury or damaged

2-384 Powerplant removed

equipment.

2-647