TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 677 of 1364

TM 9-2350-238-20-1

1

Install bulkhead disconnect to engine components and warning units branched wiring harness

(1) on powerplant.

2

Untag and connect shell connector (2) to engine oil pressure sending unit.

3

Untag and connect shell connector (3) to engine low oil pressure warning switch.

4

Untag and connect shell connector (4) to engine water temperature warning switch.

5

Untag and connect shell connector (5) to engine water temperature sending unit.

6

Untag and connect plug connector (6) to air box heater bracket receptacle connector.

7

Untag and connect shell connector (7) to line connection.

8

Untag and connect plug connector (8) to throttle limiting solenoid valve.

9

Install ground cable terminal (9) and screw (10) on bulkhead.

10

Untag and connect shell connector (11) to transmission oil high temperature warning switch.

11

Untag and connect shell connector (12) to transmission oil temperature sending unit (13).

12

Untag and connect shell connector (14) to transmission oil pressure sending unit.

13

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc.

During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-651