TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 685 of 1364
TM 9-2350-238-20-1
7
Untag and connect two shell connectors (9) to pump and igniter switch (10).
8
Untag and connect two shell connectors (11) to fuel pump switch (12).
9
Install ground cable terminal (13) and screw (14) on bulkhead.
10
Untag and connect six shell connectors (15) to line connection.
11
Connect five shell connectors (16) to driver’s instrument panel (17) at the following points:
a.
Untag and connect shell connector to master switch (18).
b.
Untag and connect shell connector to instrument switch (19).
c.
Untag and connect two shell connectors to starter switch (20).
d.
Untag and connect shell connector to line connection.
12
Install ground cable terminal (21) and screw (22) on bulkhead.
13
Untag and connect plug connector (23) to fan (24).
14
Untag and connect shell connector (25) to 15 AMP circuit breaker (26).
15
Untag and connect plug connector (27) to receptacle connector (28).
16
Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure
and all hardware is tight.
2-91. MAINTENANCE OF SUSPENSION LOCKOUT SYSTEM WARNING LIGHT
GROUND AND HORN GROUND ELECTRICAL LEADS.
This task covers:
a.
Removal
b.
Inspection/Repair
c. Installation
INITIAL SETUP
Materials/Parts
Electrical wire (figure D-2, appx D)
References
TM 9-2350-238-24P-1
Equipment Conditions
2-640
Batteries disconnected
2-952 Driver’s seat removed
General Safety Instructions
Failure to remove or disconnect
batteries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
equipment.
2-659
Back to Top
