TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 687 of 1364
TM 9-2350-238-20-1
INSPECTION/REPAIR
1
Inspect for broken, damaged, or missing
parts.
2
If damaged or missing, replace marker
bands. Etch or stamp lead number on
new band.
3
For repair of cable terminals and shell
connectors, refer to general maintenance,
page 2-371.
4
Electrical wire is a manufactured item,
refer to appendix D.
5
Repair is by replacement of authorized
parts (TM 9-2350-238-24P-1).
INSTALLATION
1
Install horn ground electrical lead (6) to
hull through driver's compartment.
2
Untag and connect shell connector (5) to
horn.
3
Connect cable terminal (4) to horn ground.
4
Install suspension lockout system warning
light ground electrical lead (3) in hull
through driver's compartment.
5
Untag and connect shell connector (2) to
suspension lockout system warning light.
6
Connect cable terminal (1) to driver's
instrument panel ground.
7
Wiring harnesses and leads are secured to
the hull and components with loop clamps,
straps, clips, ground screws, etc. During
installation, make sure the wiring harness
or lead is secure and all hardware is tight.
2-92. MAINTENANCE OF LINE CONNECTION TO RIGHT HEADLAMP DISCONNECT
BRANCHED WIRING HARNESS.
This task covers:
a.
Removal
d.
Reassembly
b.
Disassembly
e. Installation
c. lnspection/Repair
INITIAL SETUP
Materials/Parts
Electrical wire (figure D-2, appx D)
Gasket
Rod (figure D-24, appx D)
References
TM 9-2350-238-24P-1
Equipment Conditions
2-640
Batteries disconnected
2-384 Powerplant removed
General Safety Instructions
Failure to remove or disconnect
batteries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
equipment.
2-661
Back to Top
