TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 689 of 1364
TM 9-2350-238-20-1
INSPECTION/REPAIR
1
Inspect for broken, damaged, or missing
4
parts.
2
If damaged or missing, replace marker
5
bands. Etch or stamp lead number on
new band.
3
For repair of shell connectors, refer to
general maintenance, page 2-371.
Rod and electrical wire are
items, refer to appendix D.
manufactured
Repair is by replacement of authorized
parts (TM 9-2350-238-24P-1).
For reassembly of wiring harness receptacle connector, refer to general maintenance, page 2-371.
INSTALLATION
1
2
3
Install line connection to right headlamp
4
Untag and connect seven shell connectors
disconnect branched wiring harness (6) to
(1) to line connections of right headlamp
hull.
disconnect branched wiring harness.
If removed, install new gasket (5) to
5
Wiring harnesses and leads are secured to
receptacle connector (4).
the hull and components with loop clamps,
straps, clips, ground screws, etc. During
Connect receptacle connector (4) to light
installation, make sure the wiring harness
harness connector and install four washers
or lead is secure and all hardware is tight.
(3) and four screws (2).
2-93. MAINTENANCE OF TRAILER RECEPTACLE ASSEMBLY TO DISCONNECT
BRANCHED WIRING HARNESS.
This task covers:
a.
Removal
d.
Reassembly
b.
Disassembly
e. Installation
c. Inspection/Repair
INITIAL SETUP
Materials/Parts
Electrical wire (figure D-2, appx D)
Rod (figure D-24, appx D)
General Safety Instructions
References
TM 9-2350-238-24P-1
Equipment Conditions
2-640 Batteries disconnected
Failure to remove or disconnect
batteries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
equipment.
2-663
Back to Top
