TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 696 of 1364

TM 9-2350-238-20-1

2-96. MAINTENANCE OF BULKHEAD DISCONNECT TO STARTER ELECTRICAL LEAD.

This task covers:

a.

Removal

d.

Reassembly

b.

Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Materials/Parts

Electrical wire (figure D-2, appx D)

Insulation sleeving (figure D-1, appx D)

References

TM 9-2350-238-24P-1

Equipment Conditions

2-840

Batteries disconnected

2-384 Powerplant removed

General Safety Instructions

Failure to remove or disconnect

batteries before removing or installing

any electrical wiring harness or lead

may result in injury or damaged

equipment.

1

2

3

4

Failure to remove or disconnect

batteries before removing or installing

any electrical wiring harness or lead

may result in injury or damaged

equipment.

Wiring harnesses and leads are secured

to the engine with loop clamps, straps,

clips, ground screws, etc. Remove only

the hardware which secures the wiring

harness or lead being removed.

Tag and disconnect plug connector (1)

from bulkhead disconnect.

Tag and disconnect cable terminal (2)

from starter.

Remove bulkhead disconnect to starter

electrical lead (3) from engine.

2-670