TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 771 of 1364

TM 9-2350-238-20-1

Failure to remove or disconnect batteries before removing or installing any electrical

wiring harness or lead may result in injury or damaged equipment.

1

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead

being removed.

2

Tag and disconnect cable terminal (1) from generator terminal E.

3

Loosen screw (2) and disconnect cable terminal (3) from hull.

4

Remove generator to ground engine ignition lead (4) from generator.

1

Inspect for broken, damaged, or missing parts.

2

If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3

For repair of cable terminals, refer to general maintenance, page 2-371.

4

Electrical wire is a manufactured item, refer to appendix D.

5

Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

1

Install generator to ground engine ignition lead (4) to generator.

2

Connect cable terminal (3) to hull and tighten screw (2).

3

Untag and connect cable terminal (1) to generator terminal E.

4

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-745