TM-9-2350-238-34-1
HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
MARCH 1994
TM-9-2350-238-34-1 - Page 100 of 292
TM 9-2350-238-34-1
2-36. MAINTENANC E
REASSEMBLY (CONT )
7
8
9
1 0
1 1
1 2
OF SLIP RING ELECTRICAL CONTACT SET ASSEMBLY (CONT) .
NOT E
Ensure brush wire passes throug h
bottom of compression spring .
Install eight new brushes (4) in eight new
compression springs (5) .
Install eight brushes (4) and eight com-
pression springs (5) in inner contact set
holder (6) with brush wire passing through
hole in bottom of inner contact set holder.
Press eight brushes (4) up and down in
holes to ensure free movement .
Pull slack out of eight brush wires without
compressing any of the eight compressio n
springs (5) .
Solder eight brush wires to inner contact
set holder (6) per TB SIG-222.
Clip off excess wire. Ensure solder an d
wire do not rise above groove in inner
contact set holder (6).
2-8 8
Back to Top
