TM-9-2350-238-34-1
HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
MARCH 1994
TM-9-2350-238-34-1 - Page 88 of 292
TM 9-2350-238-34-1
2-34. MAINTENANCE OF SLIP RING ELECTRICAL COMPONENTS, SLIP RING DIS -
CONNECT TO INTERIOR DISCONNECT WIRING HARNESS, AND SLIP RING T O
24-VOLT FEED ELECTRICAL LEAD (CONT) .
REMOVAL (CONT )
14
Remove Iockwire (23) and four socke t
head capscrews (24) .
15
Remove slip ring to 24-volt feed electrica l
lead (18) and shell gasket (25) from slip
ring (6).
lNSPECTION/REPAIR
1
2
3
4
5
6
7
Inspect for broken, damaged, or missing parts.
For repair of slip ring disconnect to interior disconnect wiring harness and slip ring to 24-volt
feed electrical lead, refer to general maintenance, page 2-19.
Turret slip ring cover is a repairable assembly. Refer to page 2-80.
Slip ring electrical brush connector assembly is a repairable assembly. Refer to page 2-90.
Slip ring electrical contact set assembly is a repairable assembly. Refer to page 2-84.
If any kit component requires replacement, replace entire slip ring contact set assembly parts kit
or slip ring electrical brush connector assembly parts kit.
-
Repair is by replacement of authorized parts (TM 9-2350-238-24P-1) which do not meet
inspection criteria .
INSTALLATIO N
1
Install new shell gasket (1) and slip ring to
24-volt feed electrical lead (2) to slip ring
(3), and secure with four socket head cap-
screws (4) and new Iockwire (5). Pull slip
ring to 24-volt feed electrical lead (2) up
through top of slip ring.
2-7 6
Back to Top
