TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 147 of 796

EXTERIOR LIGHTING KIT INSTALLATION AND REMOVAL

INITIAL SETUP:

References

Charging vehicle batteries with Auxiliary Power

Unit (APU) (WP 0043)

Description and use of operator’s controls and

indicators (WP 0004)

Starting main engine (WP 0010)

Equipment Condition

Vehicle master power off (WP 0015)

WARNING

•

Position extension harness in location so that it does not interfere with the

movement of the vehicle during operations, or is not tripped over by the crew.

Failure to comply may result in personnel injury and/or damage to equipment.

•

Remove any rings, bracelets, wristwatches, and neck chains before working on

any vehicle. Jewelry can catch on equipment and cause injury, or may short

across electrical circuit and cause severe burns or electrical shock. Failure to

comply may result in personnel death or injury.

NOTE

If extensive light usage is required, periodically charge vehicle batteries by starting the

engine (WP 0010) or Auxiliary Power Unit (APU) (WP 0043).

GENERAL

This task covers the configuration for using all three light assemblies. However, the kit does have the flexibility to

use just one or two light assemblies. Different harness configurations can be used to position light assemblies

where needed on the vehicle.

TM 9-2350-256-10

0023

0023-1