TM-9-2350-256-24P-1
M88A1 RECOVERY VEHICLE, FULL TRACKED; MEDIUM
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST (INCLUDING DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS)
TM-9-2350-256-24P-1 - Page 23 of 1032
TM 9-2350-256-24P-1
C01
b.
PART NUMBER INDEX.
Part numbers in this index are listed by part number in ascending alphanumeric
sequence (i.
., vertical arrangement of letter and number combination which places the first letter or digit of each group in
order A through Z, followed by the numbers 0 through 9 and each following letter or digit in like order).
(1) CAGEC column.
The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric code
used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
(2) PART NUMBER column.
Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity) which controls the design and characteristics of the item by means of its engineering
drawings, specifications, standards, and inspection requirements to identify an item or range of items.
(3) STOCK NUMBER column.
This column lists the NSN for the associated part number and
manufacturer identified in the PART NUMBER and CAGEC columns to the left.
(4) FIG. column.
This column lists the number of the figure where the item is identified/located in Section
II and IIIl.
(5) ITEM column.
The item number is that number assigned to the item as it appears in the figure
referenced in the adjacent figure number column.
c.
FIGURE AND ITEM NUMBER INDEX.
(1) FIG.
column.
This column lists the number of the figure where the item is identified/located in Section
II and III.
(2) ITEM column.
The item number is that number assigned to the item as it appears in the figure
referenced in the adjacent figure number column.
(3) STOCK NUMBER column.
This column lists the NSN for the item.
(4) CAGEC column.
The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric code
used to identify the manufacturer, distributor, Government agency, etc., which supplies the item.
(5) PART NUMBER column.
Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of its engineering
drawings, specifications, standards, and inspection requirements to identify an item or range of items.
5.
Special Information.
a.
USABLE ON CODE.
The usable on code appears in the lower left corner of the Description column
heading.
Usable on codes are shown as "UOC:
........
"in the Description Column (justified left) on the first line applicable
item description/nomenclature.
Uncoded items are applicable to all models.
Identification of the usable on codes used in
the RPSTL are:
Code
Used On
C60
M88A1
b.
FABRICATION INSTRUCTIONS.
Bulk materials required to manufacture items are listed in the Bulk
Material Functional Group of this RPSTL.
Part numbers for bulk materials are also referenced in the description column of
the line item entry for the item to be manufactured/fabricated.
Detailed fabrication instructions for items source coded to
be manufactured or fabricated are found in TM 9-2350-256-20-1 and TM 9-2350-256-34-1.
c.
ASSEMBLY INSTRUCTION.
Detailed assembly instructions for items source coded to be assembled from
component part/repair parts are found in TM 9-2350-256-20-1 and TM 9-2350-256-34-1.
Items that make up the
assembly are listed immediately following the assembly item entry or reference is made to an applicable figure.
6
Back to Top
