TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 308 of 772

TM 9-2350-260-20-1-2

ENGINE FUEL PUMP REPLACEMENT (Sheet 3 of 4)

CLEANING AND INSPECTION:

1.

Using rags (Item 65, Appendix D) and dry cleaning solvent (Item 54, Appendix D), clean fitting and mounting

hardware thoroughly.

2.

Inspect fittings and mounting hardware for nicks, cracks, wear, or thread damage.

Replace if required.

INSTALLATION:

1.

Using finger install new gasket (A) on mounting

studs (B).

2.

Using 3/4 inch wrench, Install adapter (C).

3.

Using both hands, carefully install fuel pump

assembly (D) on mounting studs (B) and, at the

same time, install tube (E) into adapters (F) and

(C).

4.

Using 1/2 inch wrench, install four washer (G) and

new self-locking nuts (H) on mounting studs (B).

5.

Coat threads of all fittings with sealing compound

(Item 27, Appendix D).

6.

Using 13/16 inch wrench, install adapter (J) on fuel

pump assembly (D).

7.

Using 7/8 inch wrench, tighten line nut (K) on

adapter (F).

8.

Using 7/8 inch wrench, tighten line nut (L) on

adapter (C).

9.

Using 1/2 inch wrench, install adapter (M).

Go on to Sheet 4

TA148114

7-39