TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 302 of 772

TM 9-2350-260-20-1-2

TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT (Sheet 2 of 5)

NOTE

Use drain pan and rags to catch fuel

in hose and tube assemblies.

REMOVAL:

1.

Using 7/8 inch wrench, remove hose assembly (A)

from bulkhead elbow (B).

2.

Using 1 inch wrench to hold nut of bulkhead elbow

(B) and 7/8 inch wrench, remove tube assembly

(C) from bulkhead elbow (B).

3.

Using 3/4 inch wrench to hold bulkhead elbow (B)

and 1 inch open end wrench, remove nut,

lockwasher, and flat washer (D) from bulkhead

elbow (B).

Throw lockwasher away.

4.

Remove bulkhead elbow (B) from engine

bulkhead.

5.

Using 3/8 inch wrench and screwdriver, remove

three screws and self-locking nuts (E) from tube

clamps (F).

Throw self-locking nuts away.

6.

Using fingers, remove three tube clamps (F) from

tube assembly (C).

Go on to Sheet 3

TA148108

7-33