TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 296 of 772

TM 9-2350-260-20-1-2

FUEL RETURN LINES REPLACEMENT (2D ENGINE) (Sheet 6 of 10)

INSTALLATION:

1.

Using 15/16 inch wrench on elbow (A) and 3/4 inch wrench on vent valve (B), install vent valve (B) in elbow (A).

2.

Using 3/4 inch wrench on vent valve (B) and 7/8 inch wrench on fuel return line (C), install fuel return line (C) on

vent valve (B).

3.

Install clamp (D) on fuel return line (C).

4.

Using screwdriver and 7/16 inch wrench, install screw (E) and new self-locking nut (F) securing clamp (D).

5.

Place tube cross (G) in vie and using 7/16 inch wrench, install elbow (H) in tube cross (G).

Remove from vise.

6.

Place tube cross (G) in position and using hands, install flat washer (J), nut (K), and fuel return line (L) on tube

cross (G).

7.

Using 1-1/8 inch wrench, tighten nut (K) and fuel return line (L) on tube cross (G).

Go on to Sheet 7

TA148102

7-27