TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 495 of 772

TM 9-2350-260-20-1-2

ENGINE FUEL RETURN HOSE REPLACEMENT (Sheet 1 of 1)

TOOLS:

1 in. open end wrench

1-1/8 in. open end wrench

SPECIAL TOOLS:

Ground hop kit (Item 32, Chapter 3, Section I)

SUPPLIES:

Rags (Item 65, Appendix D)

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-1)

REMOVAL:

1.

Using 1-1/8 inch wrench to hold fitting (A) secure.

2.

Loosen fitting (B) with 1 inch wrench and remove

hose assembly (C).

INSPECTION:

Inspect hose assembly for damage or wear.

Replace if

necessary.

INSTALLATION:

1.

Hand tighten hose assembly (C) into tube

assembly fitting (A).

2.

Use 1-1/8 inch wrench to hold fitting (A) and use 1

inch wrench to tighten fitting (B).

3.

Fill fuel tanks.

4.

Attach ground hop kit (page 5-54).

5.

Start engine and allow it to run for a brief time while checking for leaks.

6.

Disconnect ground hop kit (page 5-67).

7.

Install 2A powerplant (page 5-14) or 2D powerplant (page 5.40).

End of Task

TA148301

7-226