TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 577 of 783

TM 9-2350-260-20-1-3

PARKING BRAKE GUIDE AND ROD ASSEMBLIES REPAIR AND REPLACEMENT (Sheet 8 of 14)

ASSEMBLY:

NOTE

Use

new

cotter

pins

during

installation.

1.

Insert shaft (A) in safety lock (B).

2.

Install thrust washer (C) on each end of shaft (A).

6.

Install jamnut (J) on connecting rod (K).

7.

Install rod end bearing (L) on connecting rod (K) the

same number turns recorded during removal.

8.

Aline holes in connecting rod (K) and bearing (L) as

shown.

9.

Using two 3/4 inch wrenches, tighten jamnut (J)

against bearing (L).

3.

Insert safety lock assembly (D) into guide assembly

(E) or (F).

4.

Assemble guide assembly (E) and (F).

5.

Using 9/16 inch wrench, install three screws (G) and

lockwashers (H).

Go on to Sheet 9

TA146337

13-49