TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 581 of 783

TM 9-2350-260-20-1-3

PARKING BRAKE GUIDE AND ROD ASSEMBLIES REPAIR AND REPLACEMENT (Sheet 12 of 14)

32. Install two jamnut

(AK) on parking brake rod (AL).

33. Install two rod end clevises (AM) on parking brake

rod (AL) the same number turns recorded during

removal.

34. Position holes in two rod end clevises as shown.

35. Holding clevises (AM) with adjustable wrench, and using 7/16 inch wrench, tighten two jamnut (AK) against two rod

end clevises (AM).

INSTALLATION:

1.

Position brake guide assembly (A) and connecting

rod assembly (B) in tank as shown.

2.

Using 3/4 inch wrench, install four screws, new

lockwashers, and flat washers (C) securing brake

guide assembly (A) to hull.

3.

Using long nose pliers, install spring (D).

Hook

spring (D) between bottom of safety lock (E) and

bracket on bulkhead.

4.

Position parking brake rod assembly (F) on safety

lock (E).

5.

Install straight headed pin (G) to secure parking brake rod assembly (F) to safety lock (E).

6.

Using long nose pliers, install new cotter pin (H) through straight headed pin (G).

Go on to Sheet 13

TA146341

13-53