TM 9-2350-260-20-1-3
STEERING CONTROL CONNECTING LINK REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Position washer (A) and connecting link (B) onto shaft (C).
2.
Position connecting rod (D) onto clevis of connecting link (B) and secure with bolt (E).
3.
Install connecting rod (F) onto connecting link (B) and secure with bolt (G).
4.
Using 9/16 inch socket, tighten bolts (E) and (G).
5.
Install washer (H) and shield (J) onto shaft (C) and, using 7/16 inch socket, install washer (K) and screw (L) into shield
(J).
6.
Using wrench, install washer (M) and nut (N).
7.
Using pliers, install new cotter pin (P).
8.
Install 2A powerplant (page 5-14) or 2D powerplant (page 5-40).
End of Task
TA146459
15-31