TM 9-2350-260-20-1-3
STEERING CONTROL CONNECTING LINK REPLACEMENT (Sheet 1 of 2)
TOOLS:
Flashlight
5 in. extension with 1/2 in. drive
Slip joint pliers
7/16 in. socket with 1/2 in. drive
3/4 in. combination box and open end wrench
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
SUPPLIES: Cotter pin (MS24665-287)
PRELIMINARY PROCEDURE:
Remove powerplant (page 5-1)
REMOVAL:
1.
Using pliers, remove cotter pin (A).
Throw pin (A) away.
2.
Using wrench, remove nut (B) and washer (C).
3.
Using 7/16 inch socket, remove screw (D) and washer (E).
4.
Remove shield (F) and washer (G).
5.
Using 9/16 inch socket remove two bolts (H) from connecting rods (J) and (K) and link (L).
6.
Remove connecting rods (J) and (K) from link (L).
7.
Using hands, remove connecting link (L) and washer (M) from shaft (N).
Go on to Sheet 2
TA146458
15-30