TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 753 of 783

TM 9-2350-260-20-1-3

FRONT STEERING CONTROL ROD ASSEMBLY REPLACEMENT (Sheet 2 of 3)

INSPECTION AND REPAIR:

1.

Inspect removed pin, washers, and bolt for wear or damage.

Replace if required.

2.

Inspect rod assembly (A), rod end bearing (B), and jamnut (C) for damage and wear.

NOTE

If rod assembly (A) or rod end bearing (B) is to be replaced, perform steps 3 thru 7.

3.

Measure and write down length of rod assembly between centers of the two holes.

4.

Using hammer and punch, remove pin (D).

5.

Using two wrenches, remove rod end bearing (B).

6.

Replace rod assembly (A) or rod end bearing (B) as required.

7.

Obtain length between holes same as that recorded in step 3.

8.

Install pin (D).

9.

Using torque wrench and adapter, tighten jamnut (C) to 190-195 lb-in.

21-22 N

•

m).

Go on to Sheet 3

TA146448

15-20